When cleaning boats with a crew on dry dock one must consider water usage and time to wash, as these will affect the variable costs of each unit cleaned. Additionally it will be important to average the number of boats of various sizes, which one expects to wash with the estimated time to wash each size. The amount of water anticipated in usage will be a factor also for the environmental filtering of the wash water. Most high-pressure hot water units put our about 4.6 gallons per minute to 5 Gpm; a well trained boat washing crew could clean a 30 foot hull, by doing in quarter sections at a time, in about 8-10 minutes per quarter. This is if dirty, fairly bad. But you would not be spraying the whole time. The crew would rinse it good and brush and then rinse it again. With inline injection system one might find that the length of hose was 80-100 feet and that takes 1:00 to feed soap and 1:00 to rinse. If you did this 2 times per quarter then you need to add 8 minutes to the total job. However when feeding soap the pressure is dropped down and there would be a slight different in the amount of water used but not much because even though the pumps is not working as hard the volume of water only fluctuates a little, but still realize you feed 8 more minutes at the 4.6 GPM. It maybe advisable to use a different unit to apply soap and thus saving the 8-minute feed time for soap, allow for additional dwell time of soap on the boat hull and reduce the time to clear the line for regular rinse water to move from the pump to the high-pressure spray nozzle. One could go with an airless sprayer system, Hudson industrial type spray or another cold-water pressure washer of 5 HP that put out 1.8 GPM, Honda has a nice little unit for this. However for the 4.6-5 GPM spray unit it is recommended to go with an industrial skid unit. I recommend a Hydrotek Hot Water Pressure Washer Machine for this use. http://www.hydroteksystems.com/ So lets be safe and say that you will use 58 minutes to clean the 30-foot boat hull and of that you might be spraying about 30-40 minutes for dirty boats, with film and crud on them? Now then to average out your usage think of how many boats and which sizes you will be washing, this I do not know, as each Marina will be different, however one might assume those folks with larger boats would have the money to pay you to clean them more often, this is what we have found. Now then, a not so dirty boat 30-foot you should be looking at 20 minutes wash time total minus soap feed time for inline injection unless you have another unit to spray on the soap. Below are articles I have written relating on this subject, which can assist anyone starting a boat cleaning business or expanding a current business. Think on this. http://ezinearticles.com/?Rotary-Boat-Hull-Cleaning-Systems&id=69179 http://ezinearticles.com/?Boat-Hull-Cleaning-Equipment-Needed&id=36461 http://ezinearticles.com/?Boat-Hull-Cleaning-Procedures-for-Owners-and-Detailers&id=36464 http://ezinearticles.com/?Boat-Cleaning-Business-Bilge-Clean-up-Tips&id=25176 http://ezinearticles.com/?Meguiars-RV-and-Marine-Boat-Cleaners-and-Waxes-Test-Results&id=31238%20 http://ezinearticles.com/?Future-of-Robotic-Vessel-Hull-Cleaning&id=68832 http://ezinearticles.com/?AUV-Solar-Powered-to-Monitor-Lake-Ponchartrain&id=70284 http://ezinearticles.com/?Debates-in-Auto-Detailing&id=38845 http://ezinearticles.com/?Maximum-Efficiency-in-Auto-Detailing-Shops&id=38779 http://ezinearticles.com/?Robotic-Underwater-Boat-Hull-Cleaners-Have-Military-Applications&id=68845 http://ezinearticles.com/?Boat-Washing--Spring-is-Here,-Lets-Go-Boating&id=24206 http://ezinearticles.com/?Robotic-Boat-Cleaning-is-Here,-Soon-it-will-be-Affordable&id=25574 http://ezinearticles.com/?Water-Filtration-Choice-for-Mobile-Car-Washes-and-Detailing&id=41785 http://ezinearticles.com/?Water-Softener-Use-In-Mobile-Auto-Detailing&id=41562 http://ezinearticles.com/?Boat-Cleaning-Business-Case-Study-Entrepreneurship-&id=40939 http://ezinearticles.com/?Yacht-Winterization-Service-Business&id=39752 http://ezinearticles.com/?Boat-Winterization-Services-and-Charges,-Part-I&id=39755 http://ezinearticles.com/?Boat-Winterization-Services-and-Charges,-Part-II&id=39757 http://ezinearticles.com/?Boat-Detailing-Stainless-and-Chrome-Cleaning&id=25182 http://ezinearticles.com/?Boat-and-Yacht-Detailing-Teak-Reconditioning-and-Care,-Detailing-the-Deck&id=24536 http://ezinearticles.com/?Reclaim-Equipment-Detailing-Industry-and-NPDES,-EPA,-Storm-Water-Rules&id=38599 http://ezinearticles.com/?Reverse-Osmosis-and-Deionized-Water-Filtration&id=41789 http://ezinearticles.com/?UV-Light-Water-Filtration-Devices-for-Flood-Victims&id=66501 http://ezinearticles.com/?Cleaning-Canvas-Tops-on-Boats&id=27285 http://ezinearticles.com/?Dock-and-Deck-Cleaning-Business&id=36449 http://ezinearticles.com/?Environmental-Boat-Washing-and-Detailing&id=36467 http://ezinearticles.com/?Preventing-Boat-Propeller-Injuries&id=49712 http://ezinearticles.com/?Adding-Battery-Cleaning-Services-Secrets-from-the-Auto-Detailing-Industry&id=25306 http://ezinearticles.com/?Boat-Detailing-Diagnosing-Gel-Coat-Surfaces&id=25183 http://ezinearticles.com/?Cleaning-Sails&id=27847 http://ezinearticles.com/?Advice-for-Pressure-Washing-Companies-Cleaning-Marina-Docks&id=36454 http://ezinearticles.com/?Mobile-Detailing-and-Environmental-Laws&id=27844 http://ezinearticles.com/?Environmental-Compliance-Mobile-Auto-Detailing&id=36946 http://ezinearticles.com/?Boat-Detailing-Final-Process-in-the-Reconditioning--Applying-the-Protective-Sealant-on-Gel-Coat&id=25181 http://ezinearticles.com/?Dock-Cleaning-Procedures&id=36452 http://ezinearticles.com/?Hydrofoils-as-Strike-Vehicles-on-Water-Fast,-Safe,-Smart&id=25573 http://ezinearticles.com/?Marina-Dock-Cleaning-Equipment&id=36451 http://ezinearticles.com/?Tips-on-Marina-and-Dock-Sealing&id=36456 http://ezinearticles.com/?Water-Molecule-Alignment-for-Increased-Speed-In-the-Water&id=25572 http://ezinearticles.com/?Self-Cleaning-Counters-is-a-Smart-Way-to-Prevent-Diseases-in-QSRs&id=25196 http://ezinearticles.com/?Auto-Detailing-Choosing-the-Correct-Buffing-Pads-for-the-Job&id=25179 |
